Matters needing attention when storing, installing and moulding rubber o-rings

 Date:2019/8/27 16:35:13 Hits:704

First, the storage of rubber o-rings:


1. When storing the rubber o-ring, avoid placing the rubber o-ring in a place exposed to direct sunlight.


2. Unless necessary, try not to open the o-ring repair box or packaging.


3. When storing the rubber o-ring, do not approach the high temperature heat source.


4. Do not touch ozone when storing rubber o-rings.


5. When storing the rubber o-ring, do not hang it on the needle, iron wire or rope to avoid scratching.


6, when the rubber o-ring is stored, the ambient humidity should be appropriate, try to keep ventilation.


7. When storing the rubber o-ring, do not mix it with other materials.


Second, the installation of rubber o-rings


1. Clean the installation environment, do not mix impurities into the sealing device to ensure the normal operation and use of the rubber O-ring.


2. When installing the rubber O-ring, be careful not to be cut or scratched by sharp edges such as threads or sharp corners. Be sure to leave 15°~30° between the installed shaft end and the hole end. Leading angle.


3. When installing, check the installation location is not correct.


4. Do not twist the rubber O-ring. If found, immediately rectify.


5. When installing, be sure to pay attention to the direction of the retaining ring.


6, to ensure its lubrication. Try to lubricate with the sealed liquid. If not, it must be guaranteed that the lubricant is a liquid.


7. Before installation, be sure to ensure the quality of the rubber O-ring. No burrs, internal thorns, etc., and no secondary recycling.


Third, the operation of the rubber o-ring


1. The lubrication of the rubber o-ring should be timely.


2, the use of rubber o-rings, the temperature can not be abnormally high, the pressure can not be too large.


3, the service life of the rubber o-ring must pay attention.


Fourth, the rubber o-ring mold cleaning


1. The mold of the rubber o-ring should be cleaned in time.


2. Use a special alkaline lotion to clean the mold.

Next:Congratulations on the launch of our new website
Want to see products
Product Center, Browse Product Categories
View more>>>>
Online Message
If you have purchase demand, please contact us.
Consult from here>>>>
Copyright 2019 Copyright:苏州汇威精密模具有限公司 苏ICP备11002553号-1 Technical Support: Shi Dewei Technology